All Firearms: Serial numbers will be masked off at no charge.Youth models are the same price as shown above.
Youth Models are the same price as shown above.All Firearms: Serial numbers will be masked off at no charge.
*Note: Scopes will have to be fully submerged in water and so no warranty will be issued. Check your scope prior to sending it to us.
*Note: Complete guns do not include trigger guards, floor plates, bolts or ram rods. These items can be dipped for an additional $20 each. These items will not be warranted. Please make sure you gun is fully disassembled before shipping it to us. If there has been tape, paint or any other adhesion material or rubberized coating applied to the gun, we will charge a $20 pre-treatment fee for removal. If your bow or bow parts have a rubberized coating, additional charges will apply for prep work.
All paintball guns must be disassembled prior to shipment.
You are welcome to have your items sent directly to us from any online retailer to help save on shipping.
If your bow or bow parts have a rubberized or soft feel coating, additional charges will applyfor removal of previous coatings.
Powder coated parts will not be stripped off unless powder coating finish is in poor condition.This may make for a snug fit (limb pockets, etc) which may need extra attention when puttingparts back together. We are not responsible for damage caused during reassembly.Powdercoating removal cost is $50.
*Note: Complete bow is riser and one set of limbs only. Limb pockets and limb arms which are not attached to the riser and are a separate piece (such as BowTech Guardians) will be extra as listed above. All bows must be disassembled prior to shipment. If a bow comes to us assembled, a $25 charge will be applied to disassemble it, and it will not be re-assembled afterwards. Oneida Bows have 4 regular sized limbs, which will be extra $75 to coat.
**Newer style risers may need to be double dipped in order to completely cover the whole riser. This is due to the amount of “holes or cutouts” that the riser may have. This process may give the final product a darker looking finish. ***Stabilizer prices may vary. Price is for typical simple 6″ stabilizer.
There are no reviews yet.
Your email address will not be published.
Your review *